Ip access-group sdm_fastethernet0/0_out out Ip access-group sdm_fastethernet0/0_in in Security authentication failure rate 3 logĮnable secret 5 $1$69vJ$eP09mJYo9T64iNeDbnqfz0ĭescription $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-FE 0$$ES_LAN$$FW_INSIDE$ Service timestamps log datetime msec localtime show-timezone Service timestamps debug datetime msec localtime show-timezone System image file is "flash:9.bin"Ĭisco 1841 (revision 7.0) with 115712K/15360K bytes of memory.ĭRAM configuration is 64 bits wide with parity disabled.ģ1360K bytes of ATA CompactFlash (Read/Write) ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1) isp indicates the it is ok to set to the interface to their equipment to Auto Negotiate.Ĭisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(15)T9, RELEASEĬopyright (c) 1986-2009 by Cisco Systems, Inc.Ĭompiled Tue 28-Apr-09 11:11 by prod_rel_team The a standard cat 5 cable is used to connect the 1841 to the optic device. The wiring was done before I got here and I just noticed that they used both A and B standards in the wiring. Everything runs perfectly even with reported error for approximately 10 hours Cisco 1841 monitor reports several thousand output errors on the fastethernet0/1 interface Error: interface changed state to up (also on interface to isp)
Late collision on int fastethernet0/1 (interface to isp) Cisco 1841 syslog reports the below several times every minute. IP Conflicts on workstations after hours of use
Start with one computer then cascades to the others cannot ping router inside interface. So here is the situation.Ģ0 computers (only 6-10 in use at one time) I am a canadian working in the Philippines and the tech support down here is a zoo to say the least. Hello all bare with me I am new to cisco routers.
0 kommentar(er)
